Selection tips

Waterproof and pressure-resistant, anti-corrosion structures are available, with many experiences in IP67 and IP68. Please consult with us first.

Many have been adopted in various steel mills over the world. Operates reliably even in harsh environments.

Our products are not affected by adverse environmental conditions such as oil or dust. We can offer you the right product for your application.

We have handful of products to the nuclear industry. Please contact us first.

Has been delivered to cutting machine manufacturers. Operates in environments where coolant and cutting oils are applied.

In general, sensors are less sensitive in low temperature environments. However, magnets, on the contrary, become more energetic (their magnetic force becomes stronger) and can therefore be used.

In general, magnetic weakens at higher temperatures, and the magnetism disappears permanently at certain degree of high temperature. Our standard heat-resistant-type products can be used up to 130 deg.C and of course under the blazing sun, but please consult us for detailed information.

We are often consulted in this environment. We have a lot of experience and can offer you the best solution. As well as water and dustproofing, we can also provide outdoor and lightning protection.

Our products detect magnetism and therefore operate reliably even in vibration environments.

Smaller detection head variants are also available. Also, there are many technique for mounting, sensors can be used in locations where they would normally be impossible to install.

The design of pressure-resistant structures is also one of our specialties. We have our geophysical observation instruments installed and used several ~ ten hundreds of meters under the surface where there is considerable underground pressure.

Because magnetism penetrates non-magnetic metals, our sensors can be used relatively easily even under high vacuum conditions by mounting the magnet inside the vacuum vessel and the sensor outside.

Our sensors are in use on many sites everyday. We can offer you the right sensor for your requirements.

Our sensors are not easily broken due to their simple operating principle. We take measures against salt damage as well as waterproofing.

Cutting dust and ferrous powder, which are considered harmful to magnetic sensors, have the same properties as magnetism if they are adsorbed by magnets. With the exception of high-precision sensors, no measures are required.

IP67 and 68 structure ensures reliable detection, unaffected by mud and water.

Depending on the type of chemical exposed, it is often possible to take action. We have a lot of experience with strong acids and strong alkalines. Please contact us for a flexible response.

Our products have been used in a pickling tank crane. The crane was used and sensors were operating without breaking down until 20 years after installation.

We have many constructions machinery-related products, such as rail carriages and conveyors at tunnel construction sites, turntables for dump trucks, and tunnel boring machines (TBMs).